Estimated shipping time: 25 days
The QHY5III462C is a color planetary camera and autoguider using the latest generation Sony STARVIS IMX462 back-illuminated sensor with an enhanced near-infrared response in wavelength from 800 to 1100nm. The IMX462 sensor has a resolution of 1920 x 1080 @ 2.9um pixels size, 1/3inch format, 8-bit/12-bit (output as 16-bits), USB3.0 interface, and frame rate is up to 135FPS.
The QHY5III462C pixel size and array are essentially the same as the popular QHY5III290 camera but the new QHY5III462 model offers two very significant improvements over its predecessor: Extended NIR QE (with NIR monochrome imaging capability) and sHCG or Super High Conversion Gain.
The IMX462 sensor is the newest “6th Generation” sensor from Sony. With each successive generation, Sony has made significant improvements in sensor sensitivity. In the 6th generation of sensors, back-illuminated technology is enhanced with physically deeper photo sites allowing the capture of longer wavelength photons in the red and near-infrared portion of the spectrum. The back-illuminated structure of the pixel also allows more photons, include these longer wavelength photons, to be captured in less time. This greatly improves the sensitivity of the pixel to near-infrared in the 800 – 1000nm range which is approximately doubled when compared to cameras using the back-illuminated 290 sensors.
|sHCG Mode (Super High Conversion Gain)The QHY5III462C has a “Super High Conversion Gain” capability. By using a lower capacitance, a small amount of charge can be converted to a high voltage resulting in higher sensitivity in low-light conditions. The readout noise of the QHY5III462C is as low as 0.5e-. The following pictures demonstrate the low light improvement over the 290 sensors. The QHY5III462C image is on the left and the QHY5III290C image on the right. The low light conditions and exposures are identical for each image. This image shows the QHY5III462C has higher sensitivity and SNR than the QHY5III290C in the same conditions.cameras:
Color and Monochrome Imaging with One Sensor
The filter matrix in the IMX462 uses organic dye filters. These filters are very efficient at visible wavelengths but become completely transparent in the NIR. For this reason, good RGB color balance requires an external UV/IR filter that blocks NIR wavelengths. Many color cameras build this UV/IR filter into the camera or optical window for normal color imaging. However, in order to fully exploit the capabilities of the 462C sensor, in the QHY5III462C camera, we leave this blocking out of the permanent optical path and instead supply a removable external UV/IR filter for normal RGB color imaging. We also provide an external screw-in IR850 filter that blocks visible light and passed wavelengths longer than 850nm where the RGB filters are otherwise transparent, making the QHY5III462C a dual-purpose camera.
||The following picture is taken with the QHY5III462C and IR850 infrared pass filter: